Part: Honda CL360 / CJ360 / CB360 Oil Seal Kit
Why You Need This: Drip, drip, drip... spot. Is that what your motorcycle does? Oil leaks happen and old oil seals are to blame. Lucky for you Honda only put six seals on the CL360 Scrambler / CJ360 / CB360. The oil seal kit includes seals for: the tachometer cable, shift shaft, clutch pushrod, output shaft, camshaft and kick start shaft. If you are rebuilding or doing some major service on the engine then change your oil seals out to avoid any further pavement and shoe lubrication. OEM quality just like Honda used when your bike was new. Sold as a set that compliments both the overhaul gasket kit or the service gasket kit.
- Shift Lever Seal (#4007)
- Tachometer Cable Seal (#4008)
- Clutch Rod Seal (#4009)
- Drive Shaft Seal (#4010)
- Cam/Ignition Chamber Seal (#4011)
- Kick Starter Seal (#4012)
Installation Tip: Be careful when prying out old seals as not to gouge the seat. Seals can be driven in using a socket just under the outside diameter of the seal, make sure to keep the seals square when installing.
This Oil Seal Kit Fits These Honda Motorcycles