Part: Honda CB360/ CL360 Scrambler / CJ360 Piston Rings 67mm (std. size)
Why You Need This Part: Every engine will reach a time where an overhaul is necessary. We have found the Honda CL360 Scrambler / CJ360 / CB360 have fairly stout cylinders and can often be freshened up with a cylinder hone and new piston rings. We've got the hard to find 67mm standard sized piston rings to make your engine factory fresh. These piston rings are 67MM diameter and fit the factory Honda pistons; they are standard sized and are NOT over sized. If your cylinders need to be bored, then we have over sized piston kits available. Make sure to pick up an overhaul gasket kit to make this whole process easier.
Sold as a single set, each set includes top & second ductile iron piston rings and threepiece oil ring, one set per piston, two sets needed per engine.
Installation Tip: Cylinders must be measured and checked for taper, roundness and top ridge, you will need a micrometer and either the telescoping gauges or dial bore gauge to complete this. If everything measures out then the cylinders must be cleaned up with a cylinder hone to accept new rings. We always recommend to double check machine work. Oil everything well upon assembly. Top ring has a silver face. Top and second rings are installed with the "R" marking on the rings facing up towards the crown of the piston. Oil ring is installed with the wavy spacer first and then thin rail on the top and bottom of the wavy. It makes a sandwich.