Part: Female Bullet Terminal Connectors & Covers for Honda CB175 / CB200 / CB350 / CB360 / CB450 / CB550 / CB750
Why You Need This: Female bullet terminals are a high quality replacement for the often cracked or missing originals on your vintage Honda motorcycle's wiring harness. These female terminals are for single male bullet terminal connectors; double female terminals are available. Made in Japan, our terminals are superior in quality compared to the "mystery" ones sold elsewhere. Terminals come in packs of 25, including the rubber boots. These female bullet terminals are very common on other Honda models as well as many other Japanese motorcycles from the era. If you need a more comprehensive kit, bullet terminals are available in an assortment pack as well as our electrical wiring repair kit.
This pack includes:
- 25 x Honda Female Bullet Connectors
- 25 x Honda Female Bullet Connector Rubber Covers
In addition to the bullet style terminals, the multi-spade plastic connectors in
three,
four and
six terminal configurations are available too. To finish the job correctly you will also need the
proper terminal crimpers to make sure everything is installed neat and clean like it came from the factory.
Installation Tip: Buy the
electrical terminal crimp tool...
yes you will need it to properly install these bullet terminal connectors. The connectors are crimped in three stages: 1) The inner part of the terminal crimps around the wire, 2) The outer crimp goes around the wire insulation, 3) give the inner crimp a second squeeze with the end of the crimp tool to ensure a solid connection. We also like to solder all connections too so that they are permanent. The suggested wire size for these terminals is 16 gauge. Don't forget to install the rubber boot on the wire before crimping the terminal in place. A little windex will make it easier to get the boot on the wire.
