Part: Male Bullet Terminal Connectors & Covers for Honda CB175 / CB200 / CB350 / CB360 / CB450 / CB550 / CB750
Why You Need This: Male bullet terminals are a high quality replacement for missing or damaged originals on your vintage Honda motorcycle's wiring harness. Male terminals can be used with both the single female and double female terminal connections. Made in Japan, our terminals are superior in quality compared to the "mystery" ones sold elsewhere. Terminals come in packs of 25, including the rubber boots. These male bullet terminals are very common on other Honda models as well as many other Japanese motorcycles from the 1960's and 1970's. A more comprehensive kit of bullet terminals are available in an assortment pack as well as our electrical wiring repair kit.
This pack includes:
- 25 x Honda Male Bullet Connectors
- 25 x Honda Male Bullet Connector Rubber Covers
In addition to the bullet style terminals, the multi-spade plastic connectors in
three,
four and
six terminal configurations are available too. To finish the job correctly you will also need the
proper terminal crimpers to make sure everything is installed neat and clean like it came from the factory.
Installation Tip: Buy the
electrical terminal crimp tool... yes you will need it to properly install these bullet terminal connectors. The connectors are crimped in three stages: 1) The inner part of the terminal crimps around the wire, 2) The outer crimp goes around the wire insulation, 3) give the inner crimp a second squeeze with the end of the crimp tool to ensure a solid connection. We also like to solder all connections too so that they are permanent. The suggested wire size for these terminals is 16 gauge. Don't forget to install the rubber boot on the wire before crimping the terminal in place. A little window cleaner make it easier to get the boot on the wire.
